volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Reading and Clearing Diagnostic Trouble Codes|Page 1225 > < Reading and Clearing Diagnostic Trouble Codes|Page 1223
Page 7
background image

Hint: If the readout of tailgate wiper status was OK, the fault was caused by a damaged fuse or relay. The fuse can blow if relays are activated in the
wrong order. This can happen when the key is turned from position I to position II and the wiper arm is activated at the same time.

Was the tailgate wiper status OK?

Yes - Troubleshooting procedure complete

No - Replacing the component

-------------------------------------------------

Replacing the component

Replace the wiper switch.

Other information:

-

For replacing the wiper switch: Washer / wiper switch, replacing See: Sensors and Switches/Sensors and Switches - Wiper and Washer
Systems/Wiper Switch/Service and Repair 

Select "Continue" when the fault has been remedied.

Continue - Checking components

-------------------------------------------------

Checking components

Activate the tailgate wiper. Read off the status.

Hint: If the tailgate wiper switch status is OK the fault is in the tailgate wiper.

Was the tailgate wiper status OK?

Yes - Troubleshooting procedure complete

No - Replacing the component

-------------------------------------------------

Replacing the component

Try replacing the steering wheel module (SWM).

Caution! A new control module is delivered without software. The control module must be programmed in order to function after replacement.

Other information:

-

For replacing and programming and replacing the control module: Steering wheel module (SWM), replacing See: Service and Repair/Steering
Wheel Module (SWM), Replacing 

Reading and Clearing Diagnostic Trouble Codes|Page 1225 > < Reading and Clearing Diagnostic Trouble Codes|Page 1223