XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Cable routing on the left-hand side of the bumper
-
Press up the tabs on the plates and insert the cable in the holes drilled earlier. Position the cable as illustrated
-
Route the cable to the right-hand side of the existing cable duct as before.
Cable routing on the right-hand side of the bumper
-
Press up the tab on the plate. Insert the cable in the previously drilled hole. Position the cable as illustrated.
Applies to all models
-
Press the large cable harness for the sensors into place in the existing cable duct (1) in the bottom of the rear section.