XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Applies to cars with sunroof
-
Pull off the sun roof surround at the front edge to lower the headlining slightly. The surround is securely positioned.
Applies to cars with sunroof
-
Press down the headlining at the front edge of the sun roof. Position a shim between the headlining and the roof so that there is room to install the
sensor
-
Take the sensor with the blue connector from the kit
-
Find the existing cable for the movement sensor. It is taped to the headlining at the front edge of the sun roof
-
Connect the connector to the sensor. Remove the masking tape
-
Press the movement sensor into place on top of the headlining, edge to edge with the rear edge for the cut-out for the interior lighting.
Note! The sensor must be installed straight. The sensor must not be turned more than 5 degrees.
-
Reinstall the interior lighting. Tighten the rear view mirror. Tighten to 10 Nm (7.5 lbf. ft.)
-
Reinstall the interior lighting panel.
-
Remove the cover and the screws underneath for the rear headlining
-
Carefully pry off the panel at the rear edge using a plastic weatherstrip tool
