XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
NOTE: Do not apply rust solvent spray or grease to the Heated Oxygen Sensor (HO2S) or combined instrument panel connectors.
-
Ignition off
-
Disconnect the battery negative terminal
-
Use compressed air to clean the disconnected connector
-
Apply rust solvent spray 1161422 to the disconnected connectors
-
Blow clean using compressed air.
NOTE: Do not fill the protective cover with grease.
-
Press grease, P/N 1161417-9, into the terminals directly from the tube
-
Check that all the cavities in the connectors are filled
-
Use a loose male pin to ensure that contact in sockets is good. The pin should remain in position when pulled gently.
Battery, Disconnecting
BATTERY, DISCONNECTING
Note Before Disconnecting Battery Cables
WARNING: The SRS (supplemental restraint system) is active for a certain time after the power is cut. Therefore wait three minutes before
starting work.
