XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Position a lifting table under the sub-frame
Remove the following on both sides:
-
the screws holding the sub-frame brackets in the bodywork
-
the screw for the sub-frame mounting.
Carefully lower the sub-frame.
Note: Ensure that the brake pipe clears the exhaust pipe mounting when lowering the frame.
Note: Ensure that the steering gear screws release from the sub-frame.
Transferring components
Transfer:
-
the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm. Angle-tighten 90°. Use bevel protractor 951 2050.
Tighten the rear screw. Tighten to 105 Nm. Angle-tighten 90°
-
the anti-roll bar. Tighten to 60 Nm
-
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm. Angle-tighten 60°
-
the exhaust mounting bracket. Tighten to 50 Nm
-
the shock absorber Tighten to 50 Nm
-
lower torque rod. Tighten to 65 Nm. Angle tighten 90°.
Install new pipe/hose holders.
Installing the sub-frame
