XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Note! Blow the fracture surfaces clean using compressed air before reinstalling the cap.
Removing the pistons from the cylinder block
Remove the screws for the connecting rod cover.
Lift off the cover. Ensure that the bearing cover comes with it.
Caution! The bearing covers are not interchangeable.
Install tool 999 5746 Holder See: Tools and Equipment/999 5746 Holder with thread adapter 5746-1 in the connecting rod. Press out the connecting rod
and piston.
Hold by hand so that the piston does not fall to the floor. Ensure that the bearing cover comes with it.
Place the piston and connecting rod in such a way that they can be reinstalled in the correct cylinder.
Continue with cylinders 2, 3, 4, 5 and 6 as above.
Caution! The bearing covers are not interchangeable.
Removing the screwed joint from the intermediate section
First remove the M7 screws from the intermediate section.
Then remove the M8 screws. Start at the outer edges and work alternately towards the center.
Remove the M10 screws in the same way.
Separating the intermediate section from the cylinder block
