XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Applies to cars with 6-cylinder engine
-
Take three locking sleeves from the kit and press them in over the cable joints.
-
Take a tie strap (1) from the kit and clamp the electrical cable securely with the ground cable to one of the cables for the engine block heater
/passenger compartment connector socket.
Applies to cars with V8 engine
-
Take the relay with cables and fit it on the underside of the plate beneath the headlamp. Fit the relay with the side against the plate that allows the
connector to be accessible.
-
Take a screw, washer and nut (1) from the kit. Tighten the relay to the plate.
-
Guide the relay's ground cable (2) down on the left-hand side of the side member.
-
The long thin cable (3) from the relay is routed the same way as the cables for the heater and the passenger compartment connector socket, to
enable later connection to the Accessory Electronic Module (AEM) in the cargo compartment.
-
Clamp the ground cable with the cable to the front socket using a tie strap from the kit.
Applies to cars with 6-cylinder engine
-
Take the relay with cables and place it on the underside of the plate (1). Fit the relay with the side against the plate that allows the connector to be
accessible.
-
Take a screw, washer and nut (2) from the kit. Tighten the relay to the plate.
-
Clamp the cable for the front socket at point (3) in the plastic eye for the bumper cover's mounting.
