XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
-
Reinstall the connector in the socket and refit it in the Accessory Electronic Module (AEM).
-
Reinstall the Accessory Electronic Module (AEM) with bracket.
-
Reinstall the storage box and floor hatches.
-
Reinstall the folding panel on the rear right-hand side.
-
Reinstall the sill trim panel in the right-hand rear door.
-
Press the seat belt into the end mounting.
Note! A clear click is heard when the seat belt has locked correctly with the end mounting.
Note! Also check that the seat belt has locked correctly with the end mounting by looking at the reverse of the end mounting. The position of the
lock tab against the end mounting with the seat belt fully inserted must be: A= Correct locked position. B= If the lock tab does not lock
correctly against the end mounting, see A, replace the end mounting with a new one.
Note! Check that the seat belt is secure by jerking it hard in an upwards direction.
-
Fold the carpet back on the front right-hand side, connect the cable for the passenger compartment connector socket and reinstall it.
-
Reinstall the front sill trim panel.
-
Reinstall the panel in the lower edge of the B-pillar panel.
-
Reinstall the panels over the seat mountings.
-
Reinstall the sound barrier and the centre console's side panel on the right-hand side.
-
Program the software in accordance with the service information.
Steps - apply to the S80
-
Raise the car.
-
Remove the screw (1) in the left air baffle (2) for the front brake.
-
Remove the left-hand air baffle by pulling it backwards.
-
Remove the right-hand air baffle in the same way.
