XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Pull up and align the three-way catalytic converter (TWC) against the turbocharger (TC).
Tighten the three-way catalytic converter (TWC) to the turbocharger (TC). Use new nuts. Torque tighten. See Tightening torque, B6324S See:
Engine/Specifications/Mechanical Specifications/Tightening Torque.
Install:
-
the upper heated oxygen sensors (HO2S) according to the marks made after removal. Lubricate the threads using copper paste 116 1408. Tighten
to 45 Nm.
-
lower the wiring down for the heated oxygen sensors (HO2S). Secure the wiring in the clips and clamps. Connect the wiring
-
the heat deflector plates
-
the charge air pipe for the turbocharger (TC) for cylinders 1-3
-
the engine stabilizer brace between the spring strut turrets.
Installing the flange on the pinion
Install the carrier using the marks made earlier. If necessary, use tool 999 5504 PRESS TOOL, DRIVE FLANGE See: Tools and Equipment/999 5504
Press Tool, Drive Flange.
Installing a new nut in the carrier
Install a new lubricated nut.
