XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
-
the vibration damper. Use new screws. Tighten and angle tighten. See Tightening torque, B6324S See: Engine, Cooling and
Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque. Use the crankshaft center nut as a counterhold
-
the plastic nuts for the cover in the right-hand fender liner
-
the right front wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Lower the car.
-
Remove the front timing belt cover. See Timing cover front, replacing See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing
Cover/Service and Repair.
Tension the auxiliaries belt.
-
the expansion tank
-
the hose between the expansion tank and the radiator. Remove the lock grip pliers
-
the servo reservoir
-
the upper timing belt cover.
Twist the intake pipe for the turbocharger for cylinders 1, 2 and 3 into position. Tighten the clamp.
Install the plastic hoses between the turbocharger (TC) and charge air cooler (CAC) and between the air cleaner (ACL) and turbocharger (TC).
Tighten the hose clamps.
-
the engine stabilizer brace. Tighten to 50 Nm
-
the screw holding the engine stabilizer brace to the bracket on the engine. Tighten to 80 Nm.
Final check
Check and top up if required
-
coolant level
-
the servo fluid level.
Test run the engine.
