XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
-
Disconnect the connectors for the sidemarker lamps on the left and right-hand sides. The connectors must be left in place in their brackets.
-
Drill out the rivets in the rear edge of the wheel arch on the right and left-hand sides. Use a 6 mm (1/4" ) diameter drill bit
-
Remove the remains of the rivets.
-
Pull the ends of the bumper cover away from the body. Pull off the clips (1) at the bottom and continue up along the wing extensions and pull off
the three vertically positioned clips (2)
-
Pull out the ends some more until the four horizontally positioned clips (3) at the top of the wing extensions release
-
Fold up the lower tailgate
-
Pull the bumper back so that the two clips (4) which are accessible from the space under the rear lamps release
-
Remove the bumper.
