XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Remove:
-
the tie strap around the wiring above the pump
-
the level sensor by pressing in the two clips and pulling upwards
-
the thin pipe from the holder on the outside of the fuel tank unit
-
the wiring from the holder in the fuel tank unit.
Applies to vehicles with parking heaters
If the vehicle has an engine block heater, drill out the hole connection in the fuel tank unit. Use a -4 mm drill bit. Transfer the dip pipe.
Installing the right-hand level sensor
Install:
-
the new level sensor
-
the wiring in the holder
-
the thin pipe in the holder on the outside of the fuel tank unit
-
the tie strap around the wiring above the pump
