XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Shift Interlock Solenoid: Procedures
Solenoid shift lock, replace
Note: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Remove the center console
Remove the center console.
Removing mechanical cable from gear selector assembly
Move the gear selector to position P. This is to access the cable locking.
Remove the mechanical cable lock from the gear selector lever, use pliers and pull the lock off bushing. Pull the striker plate straight up out of the
mounting which secures the solenoid.
Remove the solenoid
Carefully pull the solenoid, with its wiring, out of the gear selector assembly.
Disconnect the tab terminals.
Hint: Check that the blade terminal plus (+) and minus (-) are correctly positioned on the solenoid.
Installation
Install the solenoid
Connect the tab terminals.
Install the solenoid in the gear selector assembly cut-out. The blade terminal and the cable should be upwards in the gear selector assembly.