XC90 AWD L6-3.2L VIN 98 B6324S (2007)
-
Take the short cable harness from the kit.
-
Remove the taped connector from the cable.
-
Install the larger connector (1) with cable tie/metal clip from the kit.
-
Secure the tie strap around the connector and install the metal clip around the panel edge on the right-hand side of the car.
-
Pull the end of the cable with the loose pins into the engine compartment.
-
Route the cable (1) as illustrated. Place it under the cable duct and expansion tank so that it is concealed.
Note! Make sure that the cable is positioned so that it is not damaged by heat or wear.
-
Clamp it in with tie straps from the kit.
Steps 36 and 37 apply to left-hand drive cars
-
Raise the car.
-
Remove the engine splash guard.
-
Remove the plug from the hole in the passenger compartment. It is located under the cowl panel's insulation.
If the car has a rubber grommet without any space for more cables:
-
Remove the existing rubber grommet and replace it with the rubber grommet from the kit. Cut off the tip of one of the rubber teats.
