XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft seal rear, replacing
Special tools:
999 5651 Extractor See: Tools and Equipment/999 5651 Extractor
999 7194 Drift See: Tools and Equipment/999 7194 Drift
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the carrier plate
Remove the carrier plate. See: Carrier plate, replacing, B8444S, TF-80SC AWD See: Transmission and Drivetrain/Flex Plate/Service and Repair.
Removing the rear sealing ring
Caution! Do not damage the mating surfaces of the crankshaft and cylinder block.
Remove the old sealing ring using puller 999 5651 Extractor See: Tools and Equipment/999 5651 Extractor.
Clean around the crankshaft flange and screw holes to remove any thread sealant residue. If necessary, wash and dry away any oil from the engine's rear
engine block plane and the transmission clutch housing. Blow clean with compressed air.
