XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Receiver Dryer: Service and Repair
Receiver drier, replacing
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Note! Chassis number limit, see below. XC90 with chassis no. from and including 196988.
Preparations
Read the safety regulations for handling refrigerant acc. to: Refrigerant, safety regulations See: Service Precautions/Technician Safety Information.
Drain the refrigerant from the AC-system acc. to: Refrigerant, draining See: Service and Repair/Refrigerant, Draining.
Remove the right headlight acc. to: Headlight/bulb, replacing See: Lighting and Horns/Headlamp/Headlamp Bulb/Service and Repair/Headlight/Bulb,
Replacing.
Removing the receiver drier
Remove the splash guard under the car.
Remove:
-
the connector for the pressure sensor
-
the intermediate pipe acc. to: Pipes receiver drier, replacing, B8444S See: Hose/Line HVAC/Service and Repair/Pipes Receiver Drier, Replacing
-
the pipe coupling from the condenser
-
the screw for the bracket
-
the receiver drier.
Installing the receiver drier
Note! For tightening torques, see: See: Body and Frame/Specifications
Note! Always use new O-rings lubricated with compressor oil.
Position the receiver drier in the bracket so that the pipe from the condenser is correctly positioned.