XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Installing the cover
Note:
After installation, the cable harness under the cover will be slightly over length. Clamp it up in a suitable manner to prevent chaffing.
Tighten the screws to 10 Nm.
Note;
There is a risk of altering the brake light switch adjustment when working in the pedal box area. Please verify that the brake light adjustment is
correct after the work is performed.
Use the method in VIDA/ Vehicle communication/ BCM/ Advanced/ checking brake light switch adjustment.
Method 2 (installation of superceded harness)
Parts required;
^
Engine bay cable harness, check VIDA parts catalogue
(This will be superseded engine bay harness with an integrated cover and grommet)
Remove and discard the existing surround.
Save the screws to attach the new cover to the
plenum floor.
Install the harness as per VIDA instruction
Install the integrated harness cover
Tighten the screws to 10 Nm.
Note; There is a risk of altering the brake light switch adjustment when working in the pedal box area. Please verify that the brake light adjustment is
correct after the work is performed using the method in VIDA/ Vehicle communication/ BCM/ Advanced/ checking brake light switch adjustment
