XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Note: Check that the arrow on the cover is between the markings on the tank. If the arrow is outside the markings the fuel gauge sensor will give an
incorrect value and the float may catch against the inner wall of the tank. If not: Slacken off the screw and adjust the position of the sensor. Tighten as
above.
Finishing
Install on both sides:
-
the wiring in the sockets on the rubber seal
-
the cover over the level sensors, tighten the screws.
Connect the wiring and the connectors.
Remove the block from under the seat frame.
Install:
-
the 8 seat frame screws. Tighten to 50 Nm
-
the 2 seat frame screws. Tighten to 24 Nm.
Fold the carpet down.
Install:
-
the center rear seat. See Upholstery backrest cushion center (second row), replacing
-
the outer rear seat. See Upholstery backrest cushion outer (second row).
Replacing the fuel filter
Removal
Draining the fuel system
-
Empty the fuel injection system according to Draining the fuel system.
Removing the fuel filter
-
Remove the screw securing the clamp around the filter
