XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold absolute pressure (MAP) sensor, replacing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removal of pressure sensor inlet air
Remove:
-
the connector from the sensor
-
the 2 screws
-
the sensor by pulling it straight up.
(In the illustration, the upper engine cover and torque arm are removed to better depict the location of the sensor.)
Installation
Note! For tightening torques, see: Tightening torque, B8444S See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.
Installation of pressure sensor inlet air
Install:
-
a new sensor
-
the 2 screws; tighten
-
the connector to the sensor.
Check
Start the engine and check the function.