XC90 FWD L6-3.2L VIN 96 B6324S2 (2010)
4. Moisture on the Lens
5. Thin layer of dirt caused by dust, salt, etc
6. Strong light that saturates the image in a way that objects can not be recognized
What to do?
- Verify outside conditions noting amount of sunlight, weather, driving direction (North, South, East, West), time of day.
- Ensure the lens is clean: Clean with a soft cloth or a damp sponge. Clean the lenses carefully so that they are not scratched.
- Check the function of the lens defroster: The heater is active in temperatures below 82°F (28°C). You should be able to feel the heater with your
finger; the area around the chrome ring/lens should be "warm to the touch", or use ice spray (PN 1161731) spray on the lens and see if the ice melts.
If the system does not reset, turn the engine off and restart.
AGAIN NOTE! The BLIS system will not be reset by selecting the OFF/ON button. This will only stop/start the LED indication to the driver. The
system will still work under the same conditions in the background.
Inform the customer that the system is OK. The message is to inform the driver of the actual status of the system in the current driving conditions.
2. Camera blocked
When the camera has been reporting "Reduced function" in excess of 10 minutes without change the system shifts over to the "Camera Blocked"
message in the DIM, and will be displayed together with a constant flashing from the BLIS LED's. This is the BLIS systems way to inform the driver that
the BLIS system can't work under the current driving conditions.
Examples of conditions that may give Camera Blocked message in DIM
- During dawn / dusk - Low sun, it's dark on one side of the car and bright on the other.
- Heavy rain or snow - The camera gets blocked.
- Moisture on the Lens
What to do?
- Verify outside conditions noting amount of sunlight, weather, driving direction (North, South, East, West), time of day.
- Ensure the lens is clean - Clean with a soft cloth or a damp sponge. Clean the lenses carefully so that they are not scratched.
- Check the function of the lens defroster: The heater is active in temperatures below 82°F (28°C). You should be able to feel the heater with your
finger; the area around the chrome ring/lens should be "warm to the touch", or use ice spray (PN 1161731) spray on the lens and see if the ice melts.
If the system does not reset, turn the engine off and restart.
AGAIN NOTE! The BLIS system will not be reset by selecting the OFF/ON button. This will only stop/start the LED indication to the driver. The
system will still work under the same conditions in the background.
Inform the customer that the system is OK. The message is to inform the driver of the actual status of the system in the current driving conditions.
3. BLIS Service Required
"BLIS Service Required" message in the DIM informs the driver that there can be an internal failure within the system. i.e. communication internally
within the camera, between the cameras and car communication system or a short circuit of one of the indicator LED's. This means that there is a risk
that the camera may not correctly identify another vehicle in the detection area or being able to inform the driver.
What to do?
- Check the function of the lens defroster: The heater is active in temperatures below 82°F (28°C). You should be able to feel the heater with your
finger; the area around the chrome ring/lens should be "warm to the touch", or use ice spray (PN 1161731) spray on the lens and see if the ice melts.
- Check for any relevant Retailer Technical Journals and follow the instructions
