XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Remove:
-
the 2 screws (1)
-
the inlet hose
-
the hose clamp (2)
-
the connector (3)
-
the tie strap for the cable.
Remove the turbocharger (TC) control valve from the air cleaner (ACL) housing
Remove:
-
the plastic nut on the wheel arch side
-
the air cleaner (ACL) housing.
Replacing sensor cable, left-hand side
Insert a hand under the fuse box. Disconnect the cable from the clips on the brake cable.
Pull up the sensor until the connector for the new cable is up.
Remove the tape and connect the connector.
Install the cable in the clips on the brake cable.
Caution! The yellow markings on the cables must be in the clip.
Raise the car.
Installation
Note! For tightening torques, see Specifications See: Specifications/Tightening Torque.
Installing the sensor and the cable