XC90 FWD L6-3.2L VIN 98 B6324S (2007)
If the car has a rubber grommet with space for more cables:
-
Cut off the tip of the unused rubber teat.
-
Route the cable by the cable duct (1) and along behind the drain pipe (2). Secure using a cable tie at the cable duct.
-
Route the cable behind the cowl panel insulation (3) down along to the hole for the rubber grommet.
-
Lubricate the cable with normal soap so that the cable slides easily in the rubber grommet.
-
Thread the rubber grommet on the cable.
-
Route the cable in through the hole and press in the rubber bushing in the hole so that it seals properly.
-
Pull the cable again so that the correct length remains outside the passenger compartment.
-
Make sure that the cable's heating hose is in contact against the rubber grommet and secure it with a tie strap.
Applies to right-hand drive cars.
-
Localize the rubber bushing for the wire to the hood lock.
-
Cut off the tip of an unused rubber teat.
-
Insert e.g. a welding wire or a wire through the rubber bushing and tape the cable on the welding wire/wire.
-
Lubricate the cable with normal soap so that the cable slides easily in the rubber grommet.
-
Route the welding wire/wire and cable in through the rubber bushing.
-
Adjust it so that the correct length remains outside the passenger compartment.
-
Seal between the rubber grommet and cabling by fitting a tie strap around the rubber teat.
-
Make sure that the cable's heating hose is in contact against the rubber grommet and secure it with a tie strap.
