XC90 FWD L6-3.2L VIN 98 B6324S (2007)
out at the left-hand side of the wheel housing.
-
Clamp the cable harness into the hole in the seat mounting front member, and in the rear hole in the horizontal panel at the right-hand side of the
seat. Use tie straps (1) from the kit.
Applies to cars with three rows of seats
-
Guide in a wire or cable (1) at the rear edge of the right-hand side panel and along its inside, above the load securing eyelet brackets.
-
Route the wire/cable to the front edge of the side panel.
Applies to cars with three rows of seats
-
Tape the cable (2) to the wire and route it on at the rear edge of the side panel.
Applies when the rear side panel must be removed to facilitate cable routing. Remove:
-
four covers.
-
four screws.
-
one clip.
-
Detach the C and D panels at the lower edge.
-
Pull the side panel away and lift it off.
