GV L4-1116cc 1.1L SOHC VIN 2 2-bbl (1986)
Distributor: Service and Repair
Removal and Replacement
1.
Mark position of No. 1 cylinder spark plug wire terminal on distributor body, then remove distributor cap.
2.
Rotate crankshaft until No. 1 cylinder is at TDC of compression stroke and rotor contact is aligned with No. 1 cylinder spark plug wire terminal.
3.
Disconnect battery ground cable.
4.
Loosen distributor hold-down bolt.
5.
Label, then disconnect electrical connectors and vacuum hoses from distributor.
6.
Remove distributor from engine.
7.
Reverse procedure to install.
