GV L4-1116cc 1.1L SOHC VIN 2 2-bbl (1986)
Seals and Gaskets: Service and Repair
AXLE BOOT & SEAL REPLACEMENT
1.
Remove axle shaft as previously described.
2.
Remove snap ring from inner end of axle and slide tripod joint off spline.
3.
Remove boot, bushing and seal as an assembly.
4.
Clean polished surface of axle with suitable solvent and fine emery cloth to provide proper sealing surface.
5.
Replace sealing parts as necessary.
6.
Using tool A 70375 J or equivalent over end of axle to avoid damage to seal lip when sliding boot onto axle shaft.
