GVS L4-1116cc 1.1L SOHC VIN 2 2-bbl (1988)
PARTS:
Early and late style parts are not interchangeable. They are shown, and listed, on the attached sheet.
SERVICE:
The seal lip used on the later style knuckle should be lubricated during assembly to insure quiet operation.
TOOLS:
Wheel bearing retainer wrench #57160 is required to replace the later style wheel bearing. This wrench is octagonal in shape
similar to #57123, but is 45mm across flats vs 52mm, with a 1/2" square drive hole in the center. The tool is being shipped to
your dealership to supplement your special tool kit, with a corresponding debit of $36.96 to your Parts Account.
NOTE:
Torque setting for both early and late style bearing retainer is 43 ft.lbs. (59 N-m).
REFERENCES:
Update these references as necessary: Parts Catalog pages 24.01 and 43.01 Service Manual page 6-9.
