3.2CL V6-3.2L SOHC (2003)
Paint: Service and Repair
Undercoating
Undercoating
1. Spraying primer
Primer is used to fill cavities in the putty and primer surfacer.
-
Spray primer on the exposed area.
-
Spray 2 to 3 coats of primer over the area where you applied putty.
-
Supply primer to the back of the bumper if the damage is a tear or hole.
-
Bumper primer
-
Warm the primer if the ambient temperature is below 50 degrees F (10 degrees C).
-
Follow the bumper primer manufacturer's instructions.
-
Use a spray gun and a brush.
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
Dry the bumper primer thoroughly with an infrared dryer or other suitable methods.
2. Filling/Sanding
Apply putty to repair any holes or deep gouges.