3.2CL V6-3.2L SOHC (2003)
7. Raise the stake (A) of the spinal e nut (B), then remove the nut.
8. Remove the brake disc retaining 6 mm flat screws (A).
9. Screw two 8 x 1.25 mm bolts (B) into the disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc
excessively.
10. Remove the brake disc from the knuckle.
11. Check the front hub for damage and cracks.
12. Remove the cotter pin (A) from the tie-rod end ball joint, then loosen the nut (B).
13. Remove the tie-rod ball joins from the knuckle using the special tool.
