3.2TL TYPE S V6-3.2L SOHC (2002)
-
Mix the additive into the clear at a ratio of 1 to 5.
Adding the hardener and adjusting viscosity should be done the same way as described on the previous page.
Viscosity: 68 degrees F (20 degrees C) 13-15 sec.
15. Drying top coat
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
-
Before force drying, let it air dry for 5-10 minutes.
-
Force dry the sprayed surface under the infrared lamps for 60-90 minutes.
-
Keep the drying temperature between 140 degrees F (60 degrees C) and 158 degrees F (70 degrees C).
NOTE: Take care not to let the heat deform the part during the drying process.
16. Polishing and Buffing
-
Let the paint dry gradually, then polish the surface carefully using a polishing compound and sponge buff.
-
To remove lint or dirt, wet sand the surface with #2000 or finer paper first, then polish with compound.
NOTE: Polish all roughness caused by sanding thoroughly. To do this, first polish with very fine compound, then with ultra fine compound.
-
After polishing, remove the masking paper and tape and wash the entire vehicle thoroughly.
