3.2TL TYPE S V6-3.2L SOHC (2002)
Seat Cover: Service and Repair
Front Seat Cover Replacement
Front Seat Cover Replacement
'00-03 models: SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS section
before performing repairs or service.
NOTE:
-
'00-03 models: Seats with airbags are marked "SIDE AIRBAG" on the seat-back. Because the component parts (seat-back cover, cushion, etc.) of
seats with and without airbags are different, make sure you install only the correct replacement parts.
-
'00-03 models: Do not repair torn or frayed seat-back covers. If necessary, replace the seat-back cover.
-
Take care not to tear the seams or damage the seat covers.
-
'00-03 models: Do not touch the OPDS sensor in the seat-back pad and keep it away from oils. Oils can corrode the sensor causing it to fail.
-
Put on gloves to protect your hands.
Seat-back Cover
1. Remove the front seat.
2. '99 model: Remove the seat-back heater harness from the seat cushion.
1. Disconnect the seat-back heater connector (A).
2. Release the hooks (B), and pull back the seat cushion cover (C).
3. Release the wire tie (D).
4. Pull out the harness (E).
3. Fold the seat-back forward.
4. Remove the back panel, 4-way power seat on '99 model, 4-way power seat on '00-03 models, 8-way power seat on '99-01 models, 8-way power
seat on '02-03 models.
5. Driver's seat: Remove the clip (A), then remove the lumbar support knob (B).
