3.2TL TYPE S V6-3.2L SOHC (2002)
Power Seat Motor Position Sensor: Testing and Inspection
Power Seat Position Sensor Troubleshooting
Slide Position Sensor:
1. Remove the driver's power seat.
NOTE: Be careful to not scratch the interior trim.
2. Disconnect the 3P connector from the slide position sensor and the 20P connector from the power seat control unit.
3. Check for continuity between the No. 2 terminal of the slide position sensor and A11 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 4.
NO - Repair open in the WHT/BLK wire.
4. Check for continuity between the No. 1 terminal of the slide position sensor and A2 terminal of the power seat control unit.
5. Reconnect the 3P and 20P connectors.
Is there continuity?
YES - Go to step 5.
NO - Repair the open in the BLU/BLK wire.
6. Check for voltage between the No. 3 terminal of the slide position sensor and body ground.
Is there about 5 V?
