3.2TL TYPE S V6-3.2L SOHC (2002)
3. Peel off the undercoat.
Heat the undercoat at the weld areas of the wheelhouse and front side frame with a gas torch, and peel off the undercoat with a metal spatula.
4. Remove the wheelhouse upper member.
-
Center punch around the spot weld imprints.
-
Use the special spot cutter to drill holes at the spot weld nuggets.
-
Remove the MIG weld flange with a disc sander.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Using a chisel, pry off the welded flange from the front pillar and damper housing.
NOTE: Remove the wheelhouse upper member carefully so it can be reused.
5. Replace the front wheelhouse
-
Center punch around the spot weld imprints on the front side frame and damper housing.
-
Drill holes in the center punched areas using a spot cutter.
-
Using a chisel, pry off the welded flange.
-
Level and finish the burrs left on the welding surfaces with a sander.
6. Check the damper housing for position and damage. If necessary, replace the damper housing.
