3.2TL TYPE S V6-3.2L SOHC (2002)
NOTE: If there isn't room for spot welds, compensate by using MIG welds.
-
Plug weld the holes in the lower dashboard and damper housing with a MIG welder.
11. After the front bulkhead has been welded, weld the wheelhouse upper member.
If the upper member is to be reused, make MIG plug welds at the drilled holes.
12. Finish the welded area. Use a hammer and dolly to even out the side bulkhead and front side frame flanges for a close fit with the surface of the
