3.2TL TYPE S V6-3.2L SOHC (2002)
Wheel Speed Sensor: Testing and Inspection
VSA System
Wheel Sensor Inspection
1. Inspect the front and rear pulsers for chipped or damaged teeth.
2. Measure the air gap between the wheel sensor and pulser all the way around while rotating the pulser. Remove the rear brake disc to measure the
gap on the rear wheel sensor. If the gap exceeds 1.0 mm (0.04 inch), check for a bent suspension arm.
Standard:
Front: 0.4 - 1.05 mm (0.02 - 0.04 inch)
Rear: 0.19 - 1.14 mm (0.01 - 0.05 inch)
