Testing and Inspection for Front Brake Pad in 32TL TYPE S V6-32L SOHC (2002) Disc Brake System
Brake Pad: Testing and Inspection
Front
Front Brake Pads Inspection and Replacement
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health
-
Avoid breathing dust particles.
-
Never use an air hose or brush to clean brake assemblies. Use an OSHA approved vacuum cleaner.
1. Loosen the front wheel nuts slightly. Raise the front of the vehicle, and make sure it is securely supported. Remove the front wheels.
2. Remove the brake hose mounting bolts (A) from the knuckle.
3. Remove caliper bolt, and pivot the caliper (c) up out of the way. Check the hoses and pin boots for damage and deterioration.
4. Remove the pad shims (A), pad retainers (B), and pads (C).
5. Using vernier calipers, measure the thickness of each brake pad lining. The measurement does not include pad backing plate (A) thickness.
Brake Pad Thickness:
Standard: 10.5 - 11.5 mm (0.41 - 0.45 inch)
Service Limit: 1.6 mm (0.06 inch)
6. If the brake pad thickness is less than the service limit, replace the front pads as a set.