3.2TL TYPE S V6-3.2L SOHC (2002)
Heater Control Valve Cable: Adjustments
Heater Valve Cable Adjustment
1. From under the hood, open the cable clamp (A), then disconnect the heater valve cable (B) from the heater valve arm (C).
2. From under the dash, disconnect the heater valve cable housing from the cable clamp (A), and disconnect the heater valve cable (B) from the air
mix control linkage (C).
3. Set the temperature control button or dial on Max Cool (60 °F or 18 °C) with the ignition switch ON (II).
4. Attach the heater valve cable (B) to the air mix control linkage (C) as shown Hold the end of the heater valve cable housing against the stop (D),
then snap the heater valve cable housing into the cable clamp (A).
5. From under the hood, turn the heater valve arm (C) to the fully closed position as shown, and hold it Attach the heater valve cable (B) to the heater
valve arm, and gently pull on the heater valve cable housing to take up any slack, then install the heater valve cable housing into the cable clamp
(A).
