3.2TL TYPE S V6-3.2L SOHC (2002)
7. Measure voltage between the No.1 terminal and No.2 terminal.
Is There battery voltage?
YES - Go to step 8.
NO - Repair open in the wire between PCM (A2) and the engine mount control solenoid valve 2P connector. If the wire is OK, substitute a
know-good PCM and recheck.
8. Raise the engine speed above 1,000 rpm.
9. Measure voltage between the engine mount control solenoid valve 2P connector No.1 terminal and No.2 terminal.
Is There battery voltage?
YES - Repair short to body ground in the wire between PCM (A2) and the engine mount control solenoid valve. If the wire is OK, substitute a
known-good PCM and recheck.
NO - Go to step 10.
10. Disconnect the lower vacuum hose (A) from the engine mount control solenoid valve (B), and connect a vacuum pump/gauge to the hose. Apply
vacuum for 20 seconds.
Does the engine mount hold vacuum?
YES - Go to step 11.
NO - Either the vacuum hose or one of the engine mounts has a vacuum leak. Repair as needed.
