3.2TL TYPE S V6-3.2L SOHC (2002)
2. Remove the water bypass hoses (A). Disconnect the TCS control actuator connector (B) and the TCS control valve angle sensor connector (C)
from the TCS control valve assembly, then remove the bolt (D) securing the TCS control valve bracket (J32A2 engine).
3. Remove the Evaporative Emission (EVAP) canister hose (A) from the throttle body.
4. Remove the vacuum hose (B) and breather pipe (C), then remove the intake air duct (D).
5. Remove the throttle cable (A) and cruise control cable (B) by loosening the locknuts (C), then slipping the cable ends out of the accelerator
linkage. Take care not to bend the cables when removing them. Always replace any kinked cable with a new one.
6. Remove the engine wire harness connectors and wire harness clamps from the intake manifold.
^
Intake Air Temperature (IAT) sensor connector
^
Idle Air Control (IAC) valve connector
^
Throttle Position (TP) sensor connector
^
Manifold Absolute Pressure (MAP) sensor connector
7. Remove the Intake Manifold Runner Control (IMRC) cable from the intake manifold side (J32A2 engine).
