3.2TL TYPE S V6-3.2L SOHC (2002)
Headlamp Bulb: Testing and Inspection
WARNING: Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of
the headlight assembly.
1. Check the No.43 (20 A) and No.45 (20 A) fuses in the under-hood fuse/relay box.
Are the fuses OK?
YES - Go to step 2.
NO - Replace the fuse(s) and recheck.
2. Substitute a known-good HID bulb and turn the combination light switch ON.
Does the headlight low beam come on?
YES - Replace the original HID bulb.
NO - Go to step 3.
3. Disconnect the 2P connector from the inverter unit.
4. Turn the combination light switch ON.
5. Measure voltage between the No.2 terminal of the inverter unit 2P connector and body ground.
Is There battery voltage?
YES - Go to step 6.
NO - Repair open in the wire between the under- hood fuse/relay box and the inverter unit.
6. Turn the combination light switch OFF.
7. Check for continuity between the No.1 terminal of the inverter unit 2P connector and body ground.
Is There continuity?
YES - Go to step 8.