3.2TL TYPE S V6-3.2L SOHC (2002)
Air Bag(s) Arming and Disarming: Service and Repair
Initializing the OPDS Unit
Initializing the OPDS (Occupant Position Detection System) Unit
When the seat-back cover, seat-back cushion or (and) OPDS unit are replaced with a new one, initialize the OPDS unit links with the OPDS sensor by
following the procedure below. If your PGM Tester is equipped with software version SN110 or later, disregard the procedure below, and initialize the
OPDS unit by following the prompts in the SRS menu of the PGM Tester.
1. Set the seat-back in the normal position, and make sure there is nothing sitting on the front passenger's seat.
2. Start the engine, and turn on the air conditioning system for 30 minutes to dry any moisture from the front passenger's seat.
3. Turn the ignition switch OFF.
4. Connect the Honda PGM Tester (A) to the DLC (16P) (B), and follow the tester's prompts in the "SCS" menu (see the Honda PGM Tester
Operator's Manual).
5. Connect the SCS service connector (C) to the MES connector (2P) (D). Do not use a jumper wire.
6. Turn the ignition switch ON (II).
7. The SRS indicator light comes on for about 6 seconds and goes off. Remove the SCS service connector from the MES connector within 4 seconds
after the SRS indicator light went off.
8. The SRS indicator light comes on again. Reconnect the SCS service connector to the MES connector within the 4 seconds after the SRS indicator
light comes on.
9. The SRS indicator light goes off. Remove the SCS service connector from the MES connector within 4 seconds.
10. The SRS indicator light indicates that the OPDS unit is initialized by blinking 2 times, then stays on. If the light doesn't blink 2 times and stay on,
repeat this procedure beginning with step 1.
11. Erase the DTC(S).
12. Turn the ignition switch OFF, and wait for 10 seconds. Disconnect the Honda PGM Tester from the DLC (16P). Turn the ignition switch ON (II)
again after the procedure. The SRS indicator light comes on for about 6 seconds and goes off. If the SRS indicator light doesn't come on again
after 30 seconds, the initialization of the OPDS unit is complete and the system is OK.
