3.2TL TYPE S V6-3.2L SOHC (2002)
Fuse Block: Service and Repair
Under-dash Fuse/Relay Box
Removal and Installation
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing
repairs or servicing.
Removal
1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
3. Remove the driver's dashboard lower cover or the passenger's dashboard lower cover.
4. Remove the door sill molding, left or right kick panel and left dashboard side cover or right dashboard side cover.
5. Remove the mounting bolt, and pull the driver's under-dash fuse/relay box (A) or passenger's under-dash fuse/relay box (B) away from the body.
6. Disconnect the driver's or passenger's under-dash fuse/relay box connectors, and remove the driver's or passenger's under-dash fuse/relay box.
NOTE: The SRS main harness connector is a spring-loaded lock type.
Installation
1. Connect the connectors to the driver's or passenger's under-dash fuse/relay box, then install the driver's or passenger's under-dash fuse/relay box in
the reverse order of removal.
2. Install the left or right kick panel and access panel, and the door sill molding.
3. Install the dashboard lower cover.
4. Connect both the negative cable and positive cable to the battery, enter the anti-theft code for the radio and the navigation system, then enter the
customer's radio station presets.
5. Confirm that all systems work properly.
