3.2TL TYPE S V6-3.2L SOHC (2002)
13.
On all models except RSXs, install new clips in the seat-back panel. Turn the clips so their retaining tabs are horizontal.
14.
On all models except RSXs, reinstall the seat-back panel.
15.
On RSXs only, zip the seat-back cover closed.
16. Initialize the OPDS unit.
^
To initialize with the HDS, go to Initializing the OPDS Unit: HDS Method.
^
To initialize with the SCS service connector, go to Initializing the OPDS Unit: Manual Mode.
Initializing the OPDS Unit: HDS Method
NOTE:
Non-Acura seat covers will interfere with the performance of the OPDS and are not recommended.
1.
Adjust the front passenger 5 seat-back to an upright position, then remove anything on or near the seat.
2.
Turn the ignition switch to the LOCK (0) position.
3.
Connect the HDS to the vehicle's DLC (data link connector).
4.
Turn the ignition switch to the ON (II) position, then turn on the HDS.
5.
At the screen prompts, enter the VIN and the odometer reading. Also verify the correct date and time.
6.
From the System Selection menu, select SRS.
7.
From the Mode menu, select Miscellaneous Test.
8.
From the Miscellaneous Test menu, select OPDS
9.
Follow the remaining screen prompts to complete the OPDS initialization. If the initialization fails repeat the process two more times. If the
initialization fails again, check for set SRS DTCs, then troubleshoot them using the appropriate service manual.
Initializing the OPDS Unit: Manual Mode
NOTE:
Non-Acura seat covers will interfere with the performance of the OPDS and are not recommended.
