3.2TL TYPE S V6-3.2L SOHC (2002)
Air Bag Control Module: Service and Repair
SRS Unit
SRS Unit Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the airbag connectors.
3. Disconnect the side airbag connectors.
4. Remove the console panel.
5. Disconnect the connectors (A) from the SRS unit.
6. Remove the three Torx bolts (A) from the SRS unit, than pull out the SRS unit from the bracket.
Installation
1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit, and push them into place until they click.
NOTE: When tightening the Torx bolts to the specified torque after replacement, be careful to turn them in so that their heads rest squarely on the
brackets.