3.2TL TYPE S V6-3.2L SOHC (2002)
^
If the OPDS unit has an original part number, go to step 6.
^
If the OPDS unit has a new part number (refer to PARTS INFORMATION) or higher, go to REPAIR PROCEDURE B: OPDS SENSOR
REPLACEMENT.
6.
Recline the seat-back to access the OPDS unit mounting screws.
7.
Remove the mounting screws from the OPDS unit, and gently pull out the unit.
On 3.2CLs, first remove the four mounting bolts for the front passenger's seat, and tilt back the seat far enough to clear the center console.
8.
Disconnect the electrical connectors, then remove the OPDS unit.
9.
Install a new OPDS unit, then snap on its cover.
10.
On 3.2CLs, reinstall the front passenger seat mounting bolts. Torque the bolts to 34 N~m (25 lb-ft).
11.
Slip the seat-back cover over the OPDS unit.
12.
On 3.2CLs, MDXs, and 3.2TLs, check the attachment bosses for the clips:
^
If the attachment bosses are OK, go to step 13.
^
If the attachment bosses are deformed or damaged, do the repair procedure in S/B 02-006, Seat-Back Panel Is Loose or Detached. Then go to
step 13.
