3.2TL TYPE S V6-3.2L SOHC (2002)
Child Seat Tether Attachment: Service and Repair
Child Seat Tether Anchor Installation
'99 Model
Attachment points are provided for a rear-seat-mounted child restraint system that uses a top tether. The attachment points are located on the rear speaker
grille and on the right and left rear shelves, just behind the rear seat-back. When using a child seat with a top tether, install the child seat tether anchors
securely.
NOTE:
-
Do not remove the toothed washer from the child seat tether anchor. Use the anchor with the toothed washer attached to it.
-
When installing a child seat on the rear seat, follow the instructions of the manufacturer of the child seat.
-
Additional anchor plates are available.
1. When using the middle attachment point (A), remove the cover (B) from the rear speaker grille then go to step 4. When using the side attachment
points (C) on the rear shelves, go to step 2.
2. From inside the trunk, select one of the two side attachment points (weldnuts) and poke an awl through it to make a marker hole in the rear shelf
fabric.
3. From inside the vehicle, use a sharp knife to cut a 22 mm (7/8 in.) diameter hole in the rear shelf fabric and base at the marker hole.
4. Install the child seat tether anchor (D). Torque the bolt to 22 N.m (2.2 kgf.m, 16 lbf.ft).
Child Seat Tether Anchor Removal/Installation
'00-01 Models