3.2TL TYPE S V6-3.2L SOHC (2002)
YES - Go to step 5.
NO - Repair open in the YEL/BLK wire.
5. Reconnect the 6P and 12P connectors.
6. Check for voltage between the No. 6 terminal of the recline position sensor and body ground.
Is there about 5 V?
YES - Go to step 7.
NO - Repair the open or the short to ground in the BRN/WHT wire.
7. Check for voltage pulse between the No. 5 terminal of the recline position sensor and body ground when the recline switch moves forward or
backward.
Does voltage pulse from 0 to about 5 V alternately?
YES - Replace the power seat control unit.
NO - Check for a short in the wire. If the wire is OK, faulty recline position sensor; replace the recline motor assembly.
Front Up-Down Position Sensor:
1. Remove the driver's power seat.
NOTE: Be careful to not scratch the interior trim.
2. Disconnect the 5P connector from the front up-down position sensor and the 20P connector from the power seat control unit.
