3.2TL TYPE S V6-3.2L SOHC (2002)
1. Remove the driver's power seat.
NOTE: Be careful to not scratch the interior trim.
2. Disconnect the 5P connector from the rear up-down position sensor and the 12P connector from the power seat control unit.
3. Check for continuity between the No. 2 terminal of the rear up-down position sensor and C12 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 4.
NO - Repair open in the BRN/BLK wire.
4. Check for continuity between the No. 1 terminal of the rear up-down position sensor and C11 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 5.
NO - Repair open in the RED/BLK wire.
5. Reconnect the 5P and 12P connectors.
6. Check for voltage between the No. 5 terminal of the rear up-down position sensor and body ground.
Is there about 5 V?
YES - Go to step 7.
NO - Repair the open or the short to ground in the BRN/WHT wire.
