3.2TL TYPE S V6-3.2L SOHC (2002)
Pressure Regulating Solenoid: Testing and Inspection
A/T Clutch Pressure CNTRL S/V A/B Assembly Test
A/T Clutch Pressure Control Solenoid Valve A/B Assembly Test
1. Disconnect the 2P connectors from the A/T clutch pressure control solenoid valve A (A) and B (B).
2. Measure the A/T clutch pressure control solenoid valve A and B resistance at each solenoid valve connector.
STANDARD: Approximately 5.0 Ohms
3. If the resistance of either solenoid is out of standard, replace the A/T clutch pressure control solenoid valve A/B assembly.
4. Connect the No. 1 terminal of A/T clutch pressure control solenoid valve A/B to the battery positive terminal, and connect the No. 2 terminal to
the battery negative terminal. A clicking sound should be heard. Remove the A/T clutch pressure control solenoid valve A/B assembly, if no sound
is heard.
5. Check the fluid passage of the A/T clutch pressure control solenoid valves for dust and dirt, and clean the passage if necessary.
6. Connect the No. 1 terminal of A/T clutch pressure control solenoid valve A/B to the battery positive terminal, and connect the No. 2 terminal to
the battery negative terminal. Make sure the A/T clutch pressure control solenoid valves A (A) and B (B) move.
7. Disconnect one of the battery terminals and check valve movement.
NOTE: You can see the valve movement through the fluid passage in the mounting surface of the assembly body (C).
8. If either valve binds, or moves sluggishly, or if the solenoid does not operate, replace the A/T clutch pressure control solenoid valve A/B
assembly.
