3.2TL TYPE S V6-3.2L SOHC (2002)
Shifter A/T: Service and Repair
Shift Lever Installation
Shift Lever Installation
1. Install the shift lever assembly.
2. Turn the ignition switch ON (II), and verify that the [R] position indicator comes on.
3. If necessary, push the shift cable (A) until it stops, then release your hand. Pull the shift cable back one step so that the shift position is in [R]. Do
not push and pull the shift cable by holding the shift cable guide (B).
4. Turn the ignition switch OFF.
5. Insert a 6.0 mm (0.24 inch) pin (A) into the positioning hole (B) on the shift lever bracket base through the positioning hole on the shift lever
assembly. The shift lever is secured in the [R] position.
