3.2TL TYPE S V6-3.2L SOHC (2002)
2.
Remove the inner door handle.
3.
Remove the door panel mounting screw on the underside of the armrest. Use the trim pad removal tools to release the clips around the edge of the
door panel. Pull the door panel upward to remove it.
4.
Disconnect the electrical connectors between the door and the door panel. Set the door panel aside.
5.
Disconnect the 18P connector front the power window control unit.
6.
Remove and discard the power win low control unit.
7
Install the new power window control unit. Reconnect the 18P connector.
8.
Reinstall the door panel, the inner door handle, and the mirror mount cover.
NOTE:
The connector for the door courtesy light and trunk release button must be connected for the window to operate.
9.
Initialize the power window control unit:
^
Turn the ignition switch to ON (II)
^
Make sure the driver's window is fully closed.
^
Push down and hold the switch for the driver's window. Make sure the window goes down all the way.
^
Pull back and hold the window switch. Make sure the window goes up all the way, then hold the switch for at least another 2 seconds.
10.
Make sure the auto down and auto up functions work properly.
